POSline SM2410 Spezifikationen

Manual del UsuarioSM2410ESPECIFICACIONES SUJETAS A CAMBIO SIN PREVIO AVISO.

5Back View Bottom ViewUnit: mm (inch)*** SR (strain release) that is connected to the cablerotates 90o to comply

6Connecting to the HostThe scanner connects to a host terminal by an interfacecable. This cable connects to the scanner with a modularconnector, and

7Set Up1. With the scanner running (LED red) and the host sys-tem on, scan <Enter/Exit Programming Mode> bar-code found on the inside cover of t

8LED indicationsLED Status Indicationsoff no power applied to the scannersteady red light the scanner is on and ready toscanone blink of green lighton

9BeepsChanging Beep VolumeThe scanner can be programmed with the ProgrammingGuide to change beeper tone, volume and period. Thedefault beep volume is

10Controlling the Scanner from a Host SystemThe scanner can be controlled from the host system via theRS-232C interface. Control can be accomplished b

11Specifications OperationalLight source 650nm visible laser diodeDep

12PowerInput Voltage 5VDC+10%Power 1.0WattsOperating Current 200mA@ 5.0VLaser Class CDRH Class IIa, IEC 60825-1: Class 1EMC CE&FCC DOC complianceE

13Dimensions

14Scan FieldDEPTH OF FIELD13 mil (0.33mm) 100% UPC/EAN5.90in.7.87200.0303.90150.0100.01.9750.007.5 mil (0.19mm)146 mil (0.15mm)11.54.04.55 mil (0.127m

iNo warranty of any kind is made in regard to this material,including, but not limited to, implied warranties of mechantability orfitness for a partic

15Troubleshooting Problem Diagnostic TipsThe scanner is on butcannot read

16LED remains green. *The scanner is continuously seeinga barcode. Remove all barcode la-bels out of the scan volume of thescanner and try again.*The

Notes

Notes

Scale 1:1 Unit: mmNote: 3 Mounting Holes; size- M3*0.5, Depth=5.0Figure 1: Mounting Plate Boring Template- Back View

Scale 1:1 Unit: mmNote: 2 Mounting Holes; size- M3*0.5, Depth=4.5Figure 2: Mounting Plate Boring Template- Bottom View

ii**Move the device away from the receiver.**Plug the device into a different outlet so that the device and the receiver are on different branch

iiiLaser Safety The Omnidirectional Laser Scan Module complies

ivTable of Contents Introduction...1 Unpacking...

1Introduction This Omnidirectional Laser Scan Module is an easy-to

2Finding Your Way Around Front ViewBack View Bottom Vi

3Connecting and Mounting PowerThe scanner needs a minimum of 200mA at 5V power. Thepower

44. When the scanner powers up, LED light up in green andthe buzzer makes four short beep sounds. When theself-test is finished the LED light will tur